For the box nailing machine in cardboard machinery, while paying attention to the correct use of the box nailing machine, it is necessary to pay attention to the correct maintenance and upkeep of the machine. This is a key link in improving production efficiency and box nailing quality, and cannot be ignored. It is required to lubricate the head and punch on the machine once a day. For the fixed shaft of the head and the fixed shaft of the left and right baffle, oil should also be lubricated and cleaned at any time. The upper and lower nail head transmission shafts, bolt groove shafts, and transmission screws should also be well lubricated. The lower binding head is prone to accumulation in the punch due to some electroplating chips falling off when the flat wire is fed in. It should be cleaned and cleaned regularly. After each month, the binding head should be opened for cleaning and refueling. The three gears on the left and right baffles of the paper feeding belt bolt groove shaft should be filled with butter once a month. Clutches and brakes should prevent oil and water from entering and infiltrating. The servo motor should also be kept clean to avoid dust accumulation. Regularly clean the cooling and dust filter screen of the servo motor driver. The electrical control box must be kept clean to prevent dust accumulation and short circuit faults. Pay attention to lubricating the inner and outer transmission line axles with butter to maintain reliable flexibility. The gears and chains of the power transmission are required to be lubricated with grease once a month to prevent wear and tear of mechanical components.